The fabrication and performance of wicks for flat heat pipe applications produced by sintering a filamentary nickel powder has been investigated. Tape casting was used as an intermediate step in the wick production process. Thermogravimetric analysis was used to study the burn-off of the organic...

This study presents a design method to fabricate a novel hybrid-structure flat plate heat pipe (NHSP heat pipe) for a concentrator photovoltaic. The NHSP heat pipe is composed of a flattened copper pipe and a sintered wick structure, and a coronary-stent-like rhombic copper mesh supports the...

The energy consumption of conventional HVAC systems in cold climates is strongly influenced by the ventilation thermal loads required to keep adequate levels of indoor air quality. The improvement of the energy efficiency of such systems may be achieved using heat recovery systems consisting of...

Use of low-temperature heat sources in district heating (DH) systems is gaining attention as a climate mitigation measure. Urban excess heat (UEH) from data centres, metro stations, sewage systems and service sector buildings’ cooling system belongs to these sources. The use of UEH affects...

Spring harvested corn stover was used for direct combustion in a 146 kW dual chamber boiler designed for wood logs. Stover had a very low moisture content (6.83 ± 0.17%), a gross calorific value (GCV) of 18.57 MJ/kg of dry matter (±0.32 MJ/kg DM) and an ash content of 5.88% (±1.15%). Small...

Nowadays, on average, two thirds of the fuel energy consumed by an engine is wasted through the exhaust gases and the cooling liquid. The recovery of this energy would enable a substantial reduction in fuel consumption. One solution is to integrate a heat recovery system based on a steam Rankine...

The aim of this paper is the determination of a concentrating thermo-photovoltaic (CPV/T) system dynamic model by means of the finite element method (FEM). The system consist of triple-junction InGaP/InGaAs/Ge (indium-gallium phosphide/indium-gallium-arsenide/germanium) solar cells connected to...

This paper presents a model of a power plant condenser cooling circuit which has in addition to the classical cooling scheme heat pumps for waste heat recovery. Major source of loss for a thermal power plant is the heat rejected by the condenser which can be up to 48.9% of thermal energy at...