Showing 1 - 10 of 12
In this paper, a hybrid modeling approach is proposed to model two-phase flow evaporators. The main procedures for hybrid modeling includes: (1) Based on the energy and material balance, and thermodynamic principles to formulate the process fundamental governing equations; (2) Select...
Persistent link: https://www.econbiz.de/10008913346
In this paper, Computational Fluid Dynamics (CFD) technique is used to investigate the adaption of adjustable ejector for variable cooling loads and the characteristics of ejector pressure recovery in a multi-evaporator refrigeration system (EMERS) using R134a as the refrigerant. The performance...
Persistent link: https://www.econbiz.de/10010810976
This paper describes the development of a combined ejector-vapor compression cycle (EVCC) that uses working fluid R134a and air-cooled condensers for both sub-cycles. A large amount of experiments have been conducted to test the influence of the evaporating, generating and condensing...
Persistent link: https://www.econbiz.de/10010803777
In this paper, a CFD model calibrated by the experimental results from initial designed ejector is used to evaluate the influence of 6 key geometry parameters on the performance (entrainment ratio) of an air-cooled ejector cooling system and, consequently, to find the best design parameters. A...
Persistent link: https://www.econbiz.de/10010804139
In this paper, the Computational Fluid Dynamics (CFD) technique is used to investigate the influences of varying cooling loads on the ejector pressure recovery performance in an ejector-based multi-evaporator refrigeration system (EMERS) using R134a as the refrigerant. The performance of...
Persistent link: https://www.econbiz.de/10011055158
A bypass ejector geometry with an annular cavity in the nozzle wall was tested for various operating conditions to evaluate the entrainment performance. The results were compared with those of a conventional ejector. The data shows that the primary mass flow rate in the bypass ejector is always...
Persistent link: https://www.econbiz.de/10010810508
The present paper addresses an experimental investigation of the cold storage with liquid/solid phase change of water based on the cold energy recovery of Liquefied Natural Gas (LNG) refrigerated vehicles. Water as phase change material (PCM) was solidified outside the heat transfer tubes that...
Persistent link: https://www.econbiz.de/10010809249
This paper proposed a novel long-distance combined transmission system, in which LNG (liquefied natural gas) is transported in the pipeline and electricity is transmitted through a high-temperature superconducting cable refrigerated by LNG. Through this system, electricity and LNG could be...
Persistent link: https://www.econbiz.de/10011077719
This study presents a model-based optimization strategy for an actual chiller driven dehumidifier of liquid desiccant dehumidification system operating with lithium chloride solution. By analyzing the characteristics of the components, energy predictive models for the components in the...
Persistent link: https://www.econbiz.de/10011209515
This paper presents a model-based optimization strategy for vapor compression refrigeration cycle. Through analyzing each component characteristics and interactions within the cycle, the optimization problem is formulated as minimizing the total operating cost of the energy consuming devices...
Persistent link: https://www.econbiz.de/10010810814