Analysis of forces and stresses of horizontal axis propellers and turbines has an increased interest in recent years, because of the need to develop adequate analytical tools for the design and evaluation of wind turbines rotors.

The pitch control of wind generators is usually made by a feed back control concept. However, under the conditions where a wind speed changes very frequently due to geographic reasons of the site and the target system has large rotor inertia, the feed back signal which is applied to the control...

This paper proposes a data driven model-based condition monitoring scheme that is applied to wind turbines. The scheme is based upon a non-linear data-based modelling approach in which the model parameters vary as functions of the system variables. The model structure and parameters are...

To simplify signal analysis on wind turbine blades and enable their efficient monitoring, this paper presents a novel method of transforming blade moment signals on a horizontal axis 3-blade wind turbine. Instead of processing 3-blade moment signals directly, the proposed algorithm transforms...

Gearbox transmission system is the major part of the wind turbine drive train. Due to the manufacturing and assembling errors, lubrication condition, wear and uncertainties in material and geometric properties, the system parameters, including mesh stiffness, transmission error and damping of...

Wind tunnel experiments were conducted to investigate the influence of the flanged diffuser on the dynamic behavior of the blade of a 3 kW wind turbine shrouded with a flanged diffuser. The blade was fabricated by the skin of carbon fiber reinforced plastic and solid foam core. Tests were...

In this paper, the aerodynamic performance of wind turbine airfoils with different relative thicknesses and their modifications has been numerically investigated to facilitate a greater understanding of the effects of maximum relative thickness and its position on the aerodynamic performance...

This paper proposes a reliability model for the electrical subassemblies of geared wind turbine systems with induction generators. The model is derived considering the failure of main subassemblies and their parameters are calculated. A productivity comparison is performed between the selected...

In this paper, five typical regions of Algeria where wind is strong enough are selected. These regions usually intended for traditional agriculture are, centred around the towns of Guelma, El Oued, Tindouf, Touggourt and Tamanrasset. To make wind energy conversion available as an alternative...

This paper presents a new direct power control (DPC) strategy for a double fed induction generator (DFIG) based wind energy generation system. Switching vectors for rotor side converter were selected from the optimal switching table using the estimated stator flux position and the errors of the...