Showing 1 - 10 of 133
preliminary design tool for the turbine geometry. More detailed numerical results are then obtained with the aid of a commercial …
Persistent link: https://www.econbiz.de/10010806136
Experimental results from near shore bottom standing OWC based wave energy plants in Japan and India have now been available for about a decade. Historically the weakest link in the conversion efficiency of OWC based wave energy plants built so far has been the bidirectional turbine. This is...
Persistent link: https://www.econbiz.de/10010807027
into the design process. …
Persistent link: https://www.econbiz.de/10010807084
This paper presents the work carried out to predict the behavior of a 0.6 m impulse turbine with fixed guide vanes with 0.6 hub to tip (H/T) ratio under real sea conditions.This enhances the earlier work done by authors on the subject by including the effects of damping applied by the turbine....
Persistent link: https://www.econbiz.de/10010804413
This paper depicts numerical analysis on Impulse turbine with fixed guide vanes for wave energy conversion. From the previous investigations, it is found that one of the reasons for the mismatch between computed and experimental data is due to neglecting tip clearance ef fect. Hence, a 3-D model...
Persistent link: https://www.econbiz.de/10010804546
This study presents newly developed charts to aid in early design of impulse turbine for wave energy extraction. These …. The novel approach is applied in a case study that considers the optimum diameter design selection of next …-generation impulse turbine power take-off. This allowed the selection of the correct impulse turbine sizing for a required rated power …
Persistent link: https://www.econbiz.de/10011045916
approximation, radial basis function, Kriging and weighted average surrogates were incorporated in this problem. Same design points …. Numbers of guide vanes and rotor blades were chosen as the design variables, and the objective was to maximize the blade …
Persistent link: https://www.econbiz.de/10011076854
This paper presents a dimensional analysis for determining optimal flow discharge and optimal penstock diameter when designing impulse and reaction turbines for hydropower systems. The aim of this analysis is to provide general insights for minimizing water consumption when producing hydropower....
Persistent link: https://www.econbiz.de/10010906504
Oscillating Water Column based wave energy plants convert wave energy into low pressure pnuematic power in the form of bi-directional air flows. Air turbines which are capable of rotating uni-directionally in bi-directional air flow, otherwise also known as self-rectifying turbines, are used to...
Persistent link: https://www.econbiz.de/10010806378
The aim of this investigation was to develop an environmentally friendly nano-hydraulic turbine utilizing waterfalls. A model of an impulse type hydraulic turbine constructed and tested with an indoor type waterfall to arrive at an optimum installation condition. Effects of an installation...
Persistent link: https://www.econbiz.de/10010804498