A new type of thermoelectric generator (TEG) system based on liquid metal which serves to harvest and transport waste heat, is proposed in this paper. To demonstrate the feasibility of the new TEG system, an experimental prototype which combined commercially available thermoelectric (TE) modules...

The performance of a thermoelectric generator, among other aspects, depends on the use of an effective heat sink. While forced cooling using either air or water (or other coolants) is efficient, it is parasitic on the generated power and/or bulky and inconvenient. Heat pipes are known to be...

The European Energy Efficiency Building Directive 2002/91/CE, as well as other acts and funding programs, strongly promotes the adoption of passive strategies for buildings, in order to achieve indoor thermal comfort conditions above all in summer, so reducing or avoiding the use of air...

In this work the effect of the elbow-bend geometry and the effect of the tube arrangement on the performance of air-to-water heat exchanger is studied experimentally. In elbow-bend heat exchanger, the direction of the working fluid is bended at 90 degrees to its inlet direction. The heating or...

The article provides a review of solar radiation for this climatological zone, a solar house with a water flat plate collector and three storage solar heating systems, and industrial systems which was designed and constructed in order to drying ceramic and fluidization of bituminous asphalt mixing.

The performance of a novel heat exchanger unit (‘Solasyphon’) developed for a solar hot water system was experimentally investigated under indoor and outdoor operating conditions. The ‘Solasyphon’ can be easily integrated to an existing single-coil hot water cylinder avoiding the need...

The numerical solution of complex heat exchange with account of phase transitions in secondary contour is obtained. Temperature, pressure and evaporation distributions along height of a heat exchanger and parametrical dependences of phase transitions boundaries on initial conditions are found.

One of the most commonly used heating devices in geothermal systems is the heat exchanger. The output conditions of heat exchangers are based on several parameters. The heat transfer area is one of the most important parameters for heat exchangers in terms of economics. Although there are a lot...

Energy and material saving considerations, as well as economic incentives, have led toward making effort for producing more efficient heat exchange equipment such as solar air heaters, heat exchangers. In order to enhance the heat transfer rate to flowing air in the duct of solar air heater and...

The use of renewable energies in Spain is growing; nevertheless, up to now, a very low use of geothermal energy is found. In this paper, the use of low enthalpy geothermal energy that consists of converting mine galleries in underground heat exchangers is described and analysed. The system would...