The study deals with a solar or waste heat driven three-bed adsorption cooling cycle employing mass recovery scheme. A … driven by exploiting solar/waste heat of temperatures between 60 and 90°C with a cooling source at 30°C for air …-conditioning purpose. The performance of the three-bed adsorption chiller with mass recovery scheme was compared with that of the three …

The transient state heat transfer formulation has been used to determine the air conditioning cooling load for two … transient conduction heat transfer equations. A computer program was developed to analyse the thermal network and to determine … the cooling load for the wall, roof, window, ventilation and the total cooling load for each building for a typical hot …

Transient solutions were obtained for heat transfer through a semitransparent porous medium placed in a flow passage …

of different parameters on the transient current density behavior is studied. Single phase and two phase models are …

Carrier lifetime (τ) and back surface recombination velocity (S) are determined from transient measurements with solar …

The transient phenomenon of fuel cell with 5cm2 active area is investigated in this study by current density step …

transient value of the mass of adsorbed water and desorbed water was measured for different values of the bed length. The … air humidity and velocity on the adsorption process for each bed layer was studied at different inlet velocities and at …

investigated in this study. The reaction was performed with and without adsorption of water in order to verify the effect of … methanol, conversions over 99%mol were observed. Simultaneous water adsorption allowed the use of lower alcohol/oil molar …

A solar powered adsorption refrigerator using the pair activated carbon AC35-methanol is presented in this paper. It …

processes has shown that the entire portion of the particle is not participating effectively during adsorption as well as … well with the experimental results from the literature for both desorption and adsorption processes. From the theoretical … 20.46% in total mass adsorbed and desorbed respectively are obtained. At the time when adsorption process ends, an …