A thermoelectric (TE) cooler architecture is presented that employs thin film thermoelectric elements on a plastic substrate in a corrugated structure sandwiched between planar thermal interface plates. This design represents a hybrid of a conventional bulk TE device and an in-plane thin film TE...

A study has been conducted to compare the performances of the four novel RV (revolving vane) expander design variants at suction pressures of between 2 and 30 bars, a constant discharge pressure of 1 atm and operating speeds of between 600 and 1800 rev min−1. The aspects considered were...

This paper presents a methodology to systematically formulate a hybrid renewable energy system (HRES), which consists of solar, wind and diesel generator as a backup resource as well as battery storage, from the preliminary design stage to the optimal operation. Detailed modeling of each system...

Renewable energy can help developing countries meet their sustainable development goals through access to clean, secure, reliable and affordable energy. The scarcity and the depletion of conventional energy resources, with rising fuel prices and harmful emissions from fossil fuels, make...

A large number of heat flows at various temperature and pressure levels exist in a polygeneration plant which co-produces electricity and chemical products. Integration of these external heat flows in a heat recovery steam generator (HRSG) has great potential to further enhance energy efficiency...

This work represents the Photovoltaic section of the European Project PERSIL, which includes also the study of solar thermal plants. The activity is twofold: the results of 1-year monitoring and checking of thirteen PV systems; the consequent guidelines for the design, installation and...

This paper investigates the possible site matching of the direct-drive wind turbine concepts based on the electromagnetic design optimization of permanent magnet (PM) generator systems. Firstly, the analytical models of a three-phase radial-flux PM generator with a back-to-back power converter...

Combined heat and power (CHP) plants are characterized by high fuel efficiency and are therefore usually the thermal power producing units of choice within a district heating network. The operation of CHP units is typically controlled by the current heat demand and thus delimits the range of...

The present work deals with a numerical procedure for optimizing a cooling channel with staggered elliptic dimples to enhance heat transfer and also to reduce the pressure loss. Three-dimensional Reynolds-averaged Navier–Stokes analysis is employed in conjunction with the SST model for...