Waste heat recovery systems can produce power from heat without using fuel or emitting CO2, therefore their implementation is becoming increasingly relevant. The Kalina cycle is proposed as an efficient process for this purpose. The main reason for its high efficiency is the non-isothermal phase...

The feasibility of using finned oscillating heat pipes (OHPs) for heat exchange between counter-flowing air streams in HVAC air systems (i.e., outdoor and exhaust air flows), along with the associated cost savings in typical North American climates, is investigated. For a prescribed temperature...

The feasibility of using finned oscillating heat pipes (OHPs) for heat exchange between counter-flowing air streams in HVAC air systems (i.e., outdoor and exhaust air flows), along with the associated cost savings in typical North American climates, is investigated. For a prescribed temperature...

Lignite is a kind of low rank coal with high moisture content and low net heating value, which is mainly used for electric power generation. However, the thermal efficiency of power plants firing lignite directly is very low. Pre-drying is a proactive option, dehydrating raw lignite to raise its...

EVs (Electric vehicles) have garnered much of attention over the past few decades as a promising solution to greenhouse gases in transportation. In this paper, a feasibility study is performed applying a TE (thermoelectric) device to the energy storage system of an electric vehicle. By applying...

The application of a TEG (thermoelectric power generator) to harvest energy from the waste heat of a commercial table lamp was investigated experimentally as well as numerically. The table lamp was integrated with TEG chips which were cooled by a natural convection heat sink. In the simulation,...

This paper presents the modeling and model validation for a modular two-phase heat exchanger that recovers energy in heavy-duty diesel engines. The model is developed for temperature and vapor quality prediction and for control design of the waste heat recovery system. In the studied waste heat...

The recovery of energy from exhaust gases using thermoelectric generators is of growing interest. The electrical loading of the thermoelectric system impacts the amount of energy that can be recovered. This paper presents a model for the theoretical limit of electrical power generation that...

A fin-and-tube evaporator can be used for an ORC (organic Rankine cycle) to collect waste heat of the exhaust gas of an internal combustion engine. In this paper, the thermal-hydraulic characteristics of an ORC evaporator are analyzed using a CFD method. A 3D numerical model is derived from an...