The application of a TEG (thermoelectric power generator) to harvest energy from the waste heat of a commercial table lamp was investigated experimentally as well as numerically. The table lamp was integrated with TEG chips which were cooled by a natural convection heat sink. In the simulation,...

Thermoelectric devices can provide clean energy conversion and are environmentally friendly. However, few studies have been conducted to understand the dynamic characteristics of (thermoelectric generators) TEGs. The stability of output performance plays a very important role in TEG. Based on...

A new type of thermoelectric generator (TEG) system based on liquid metal which serves to harvest and transport waste heat, is proposed in this paper. To demonstrate the feasibility of the new TEG system, an experimental prototype which combined commercially available thermoelectric (TE) modules...

Thermoelectric generator (TEG) is a promising energy conversion device for vehicle exhaust waste heat recovery. Although TEG is desired to work under composite modes and operating conditions, the influence of start-up mode on the performance of TEG was rarely paid attention to. In this study,...

This paper presents the modeling and model validation for a modular two-phase heat exchanger that recovers energy in heavy-duty diesel engines. The model is developed for temperature and vapor quality prediction and for control design of the waste heat recovery system. In the studied waste heat...

In heat exchanging devices of ammonia–water based power generation cycles for the recovery of waste heat in the form of sensible energy, assessment of pinch point (PP) is far more complicated compared to the case of working fluid of pure substance. In this study, efficient and novel method is...

This study evaluates the vehicle exhaust WHR (waste heat recovery) potential using a RC (Rankine cycle ). To this end, both a RC thermodynamic model and a heat exchanger model have been developed. Both models use as input, experimental data obtained from a vehicle tested on a chassis...

Exergy change rate in an ideal gas flow or an incompressible flow can be divided into a thermal exergy change rate and a mechanical exergy loss rate. The mechanical exergy loss rates in the two flows were generalized using a pressure-drop factor. For heat exchangers using in waste heat recovery,...

The feasibility of using finned oscillating heat pipes (OHPs) for heat exchange between counter-flowing air streams in HVAC air systems (i.e., outdoor and exhaust air flows), along with the associated cost savings in typical North American climates, is investigated. For a prescribed temperature...