The thermal evaluation of different absorber configurations for a volumetric solar receiver designed for a solar furnace has been carried out by means of commercial Computational Fluid Dynamics (CFD) software in a 2D numerical model. Simulation results for proposed configurations depending on...

A computational analysis of heat transfer augmentation and flow characteristics due to artificial roughness in the form of ribs on a broad, heated wall of a rectangular duct for turbulent flow (Reynolds number range 3000–20,000, which is relevant in solar air heater) has been carried out....

A mixed-mode natural convection solar crop dryer (MNCSCD) designed and used for drying cassava and other crops in an enclosed structure is presented. A prototype of the dryer was constructed to specification and used in experimental drying tests. This paper outlines the systematic combination of...

Artificial roughness in the form of repeated ribs is one of the effective way of improving the performance of a solar air heater ducts. Various studies have been carried out to determine the effect of different artificial roughness geometries on heat transfer and friction characteristics in...

This paper considers that the case for using electrohydrodynamic (EHD) enhancement of heat transfer has been established, especially in thermodynamic renewable energy applications where temperature levels are relatively low. It goes on to establish the basis on which nucleate boiling heat...

An increased interest in absorption chillers has been observed [1] because these systems can utilize solar, geothermal and biomass energy sources, but also because they are quiet, vibration-free, require little maintenance and are ecological [2]. Instead of a compressor system, which uses...

A population balance model is presented for describing the direct particle-to-particle heat transfer in fluid–solid processing systems. In developing the model, simple kinetic equations are assumed to describe the heat transfer process, but the particle–particle interactions are considered...

Adsorption refrigeration and heat pump systems have been considered as important means for the efficient use of low-grade thermal energy of 60–150°C. Sorption systems are merely thermodynamic systems based on heat exchangers, and therefore a good design to optimize heat and mass transfer with...

The heat transfer characteristics during melting of the (phase change material) PCM dispersed inside an emulsion are investigated theoretically and experimentally by using (differential scanning calorimeter) DSC. Genetic algorithm is used to determine the unknown parameters in the physical...

Exergy transfer analysis is proposed as a complementary method for analyzing and better understanding of the efficiency of microwave heating systems, which play a key role in medicine, chemical engineering, food industry and material processing. Since this method is able to detect and quantify...