Showing 1 - 10 of 36
The purpose of this study is to investigate the torrefaction behavior of woody biomass (Lauan) blocks and its influence on the properties of the wood. Three different torrefaction temperatures of 220, 250 and 280 °C, corresponding to light, mild and severe torrefactions, and four torrefaction...
Persistent link: https://www.econbiz.de/10011054457
The improvement on physical and chemical properties of pulverized biomass from torrefaction is investigated to evaluate the potential of biomass as solid fuel used in boilers and blast furnaces. Three biomasses of bamboo, banyan and willow are considered. The results indicate that when the...
Persistent link: https://www.econbiz.de/10011040486
The properties of biomass can be improved via torrefaction, and torrefied wood is a fuel with the potential to partially replace coal. In this study, raw Cryptomeria japonica (WRaw) is torrefied at 250 (TW250) and 300°C (TW300) for 1h, and then mixed with an anthracite coal to undergo...
Persistent link: https://www.econbiz.de/10011040573
Oxidative torrefaction is a method to reduce the operating cost of upgrading biomass. To understand the potential of oxidative torrefaction and its impact on the internal structure of biomass, non-oxidative and oxidative torrefaction of two fibrous biomass materials (oil palm fiber and coconut...
Persistent link: https://www.econbiz.de/10011040574
Persistent link: https://www.econbiz.de/10012547028
Microalgal biomass is an essential source of renewable energy and the production of high-valued bio-products. Nannochloropsis sp. is a marine microalgae which contains high valued bio-compounds. However, it contains elevated moisture which hinders extraction of important significant...
Persistent link: https://www.econbiz.de/10012833325
The reaction phenomena of CPOM (catalytic partial oxidation of methane) in a Swiss-roll reactor are studied numerically where a rhodium-based catalyst bed is embedded at the center of the reactor. CO2 is added into the feed gas and excess enthalpy recovery is performed to evaluate their...
Persistent link: https://www.econbiz.de/10011209539
Reactions of pulverized coal injection (PCI) in a blast furnace were simulated using a drop tube furnace (DTF) to investigate the burnout behavior of a number of coals and coal blends. For the coals with the fuel ratio ranging from 1.36 to 6.22, the experimental results indicated that the...
Persistent link: https://www.econbiz.de/10010807385
To evaluate the potential of pulverized coals partially replaced by rice husks used in blast furnaces, thermal behavior of blends of rice husks and an anthracite coal before and after passing through a drop tube furnace (DTF) was investigated by using a thermogravimetry (TG). For the blends of...
Persistent link: https://www.econbiz.de/10010811187
Persistent link: https://www.econbiz.de/10007730104