Showing 1 - 10 of 3,318
Simultaneous multi-variable gradient-based optimization with multi-start is performed on a 300 MWe wet … contact separation column. Optimization enables ideal flexibility in the processes: when changing the coal utilized, the …. Recently proposed thermodynamic criteria are used as embedded design specifications in the optimization process, rendering it …
Persistent link: https://www.econbiz.de/10011055237
Simultaneous multi-variable gradient-based optimization is performed on a 300 MWe wet-recycling pressurized oxy …. Optimization involves 17 optimization variables and 10 constraints, with the objective of maximizing the thermal efficiency. The … optimization procedure utilizes recent design rules and optimization procedures for optimal Rankine cycle performance speeding up …
Persistent link: https://www.econbiz.de/10011054493
in the heat exchanger is increased. Multi-objective optimization, for area and power requirements, is performed and the …
Persistent link: https://www.econbiz.de/10010808775
then performed with variable loads to determine the level of performance decrease if no optimization is performed. Finally …, optimization of operation for a fixed design, and simultaneous optimization of design and operation are performed. The design … optimization for a specific load does not include the redesign of the turbines to a process specifically designed for this load …
Persistent link: https://www.econbiz.de/10010906851
system integration schemes must be captured in order to conduct meaningful process flow and optimization studies where …
Persistent link: https://www.econbiz.de/10010807574
Vapor recompression heat pumps are used in distillation processes to reduce energy consumption. For sub-ambient distillation, one of the largest difficulties is to produce liquid reflux since the condensation of highly volatile components requires expensive refrigeration energy. Thermally...
Persistent link: https://www.econbiz.de/10010808762
In this study, an exergy-based system level methodology is conducted to assess the energy penalty reduction potential of different configurations of first generation oxy-fired pulverized coal power plants. Once the process improvement potential is identified by exergy analysis on an oxy-fired...
Persistent link: https://www.econbiz.de/10010810952
Four different integration schemes for the Advanced Zero Emissions Power (AZEP) cycle with a parabolic trough are proposed and analyzed: vaporization of high-pressure stream, preheating of high-pressure stream, heating of intermediate-pressure turbine inlet stream, and heating of low-pressure...
Persistent link: https://www.econbiz.de/10010811022
In order to design ITM-based oxy-combustion power cycles, various reactor engineering analyses must be conducted with detailed modeling and simulation. An intermediate-fidelity ITM model is used to explore the dependence of ITM performance on reactor geometric structure, flow configuration,...
Persistent link: https://www.econbiz.de/10010811403
This paper presents a detailed study on the effect of temperature on the concentration of 27 major and trace elements in bottom ash generated from oxy fuel-combustion. The major elements are Na, Mg, Al, K, Ca and Fe and the minor and trace elements are Li, Cr, V, Mn, Sr, Ba, Cu, Zn, Rb, Co, Ni,...
Persistent link: https://www.econbiz.de/10011041111