Electroless nickel composite coatings possess excellent mechanical and tribological properties such as, hardness, wear … the particle incorporation in the coating and its effect on coating structure, hardness, wear resistance, friction … electroless nickel composite coatings by incorporating different types of hard/soft particles (micro/nano size) in the electroless …

An experimental study has been carried out to investigate the reciprocating friction and wear characteristics of woven … glass epoxy composites filled with Al particulate using a reciprocating friction and wear tester. The fiber weight fraction …-up technique followed by light compression moulding. Friction and wear behavior under dry reciprocating condition has been …

The wear phenomenon in friction clutches involves a variation in the contact pairs characteristics, defining a decay of … load and sliding speed. Friction coefficient and wear rate trends were outlined to define material characteristics through … transmissible torque properties. For multidisk clutch packs installed in electro-actuated differentials, the friction torque …

Friction and wear behavior of electroless Ni-P coating under lubricated condition is studied on a block – on – roller …). Significant improvement in wear depth and COF of electroless Ni-P coating is observed under lubrication. Optimization of wear … type tribo – tester by varying applied normal load, sliding speed of the roller and sliding time. Electroless Ni-P coating …

and wear properties of the bulk metallic glass (BMG). To improve the friction and wear properties of the BMG, the disk …-alloys. The friction and wear test was performed using flat-on-flat contact configuration of unidirectional tribometer and Si3N4 …-energy dispersive spectroscopy (SEM-EDS). The results indicated that the friction and wear properties of the BMG depend on the glass …

polyester (WGRP) composite were carried out. Friction and wear characteristics of the WGRP composite were measured in three …-on-disc (POD) machine under dry sliding conditions against a smooth stainless steel counterface. Results of friction coefficient … and wear resistance of the composites were presented as function of normal loads (30–100 N) and sliding distances (0 …

-on-disc type. Friction coefficient and wear of non-commercial and commercial brake pads were measured against each counterdisc (GCI … and DGCI) and compared. Then, the friction and wear characteristic are discussed by comparing the experimental results … obtained for each kind of cast iron.The results showed that maximum friction coefficient (0.4–0.5) of brake pad was attained at …

The purpose of this study was to determine the friction coefficients and wear rates of six commercially available …. The wear tests were performed by means of a pin-on-disk type tribometer. The friction coefficients and specific wear rates … morphology of the wear tracks was examined using a scanning electron microscope. Statistical analyses were made using one …

using optical microscope. Friction coefficient and specific wear rate were presented as a function of sliding distance (0 … results showed that all test parameters have significant influence on friction and wear characteristics of the composites …. Moreover, friction coefficient increased as the normal load and speed increased, the values were about 0.7–0.9 under dry …

polished stainless steel counterface is investigated using a pin-on-disc machine. Wear and friction characteristics of oil palm …-performance of OPRP composite and neat polyester. The presence of oil palm fiber in the polyester enhanced the wear property by about … three to four times compared to neat polyester. In addition, the friction coefficient of OPRP composite was less by about 23 …