Showing 1 - 10 of 797
waterborne intumescent fire-retardant coating. The influence of graphene (GR) on the properties of the intumescent fire …-retardant coating was studied by fire protection test, TGA, SEM and smoke density test. The results showed that the GR can effectively … with GR had excellent intumescent effect and enhanced foam structure. The smoke density test of the coating demonstrated …
Persistent link: https://www.econbiz.de/10012652315
waterborne intumescent fire-retardant coating. The influence of graphene (GR) on the properties of the intumescent fire …-retardant coating was studied by fire protection test, TGA, SEM and smoke density test. The results showed that the GR can effectively … with GR had excellent intumescent effect and enhanced foam structure. The smoke density test of the coating demonstrated …
Persistent link: https://www.econbiz.de/10012181421
-fine carbide. Phase composition and microstructure of as-sprayed coating were characterized by X-ray diffraction (XRD), scanning …TiC-based wear resistant coating was prepared by plasma spraying using reconstituted composite powders doped with ultra … performed by using a ring-on-block tester under dry sliding condition. Results show that the coating adheres well to the …
Persistent link: https://www.econbiz.de/10005047106
This article examines the temperature-dependent conduction mechanism in graphene oxide (GO) and thick reduced graphene …
Persistent link: https://www.econbiz.de/10012047623
temperature in air. The effect of different annealing temperatures on the composition, the microstructure, the surface morphology …
Persistent link: https://www.econbiz.de/10011011156
A series of Zn1-xMgxO (x = 0 ~ 0.16) films have been prepared on glass substrates by RF magnetron sputtering. The structure, surface morphology, composition, optical and electrical properties of the films were investigated by X-ray diffraction (XRD), scanning electron microscope (SEM), energy...
Persistent link: https://www.econbiz.de/10011011191
Copper indium diselenide (CuInSe2) thin films were grown on indium–tin oxide (ITO)/soda-lime glass using a one-step cathodic electrodeposition process at potentials lower than -0.6 V vs SCE, and in the presence of a large excess of In3+. The source solution contained CuCl2, InCl3, and H2SeO3...
Persistent link: https://www.econbiz.de/10005080531
Thin silicon films were deposited by the plasma-enhanced chemical vapour deposition method using microwave (MW) and standard radio frequency (RF) gas discharge in silane gas diluted by hydrogen in the range that produces a mixture of amorphous and crystalline phases. The samples were analysed by...
Persistent link: https://www.econbiz.de/10010806061
The nonresonant Raman spectra of infinite peapod were calculated in the framework of bond-polarization theory by using either direct diagonalisation of dynamical matrix or the spectral moments method. The effect of C60-tube interaction on the mode frequencies both of the peas and the pod has...
Persistent link: https://www.econbiz.de/10010872535
Boron-doped hydrogenated amorphous carbon (a-C:B:H) thin films have been deposited by radio frequency plasma-enhanced chemical vapor deposition (r.f. PECVD) with a frequency of 13.56 MHz at room temperature using pure methane as a precursor of carbon source mixed with hydrogen (H2) as a carrier...
Persistent link: https://www.econbiz.de/10004971853